Custom Round Glass Table Top — Made to Your Exact Size

• Diameter — from 8 inches up to 74 inches, in whole inches plus a fraction down to 1/16 of an inch
• Glass — clear, gray, bronze, opaque or HDglass
• Thickness — from 1/8 inch to 3/4 inch, depending on size
• Edge finish — flat polish, pencil polish, beveled or seamed
• Temper mark — with or without the tempering stamp
• Centre hole — for a parasol, or none

We cut round tops from 8 inches up to 74 inches in diameter. You can specify a diameter down to 1/16 of an inch, and every piece is cut to within 1/8 of an inch of the size you give us.

That tolerance is why the measuring advice below matters. Where a table is slightly out of round, order to the smaller of your two measurements: a top fractionally under will seat correctly, one fractionally over will not sit at all.

Measure the diameter across the widest point, passing through the centre. Then measure again at ninety degrees to the first. Older tables and bases are rarely perfectly round, and if the two figures differ, order to the smaller one.

If the glass drops into a recess or sits inside a lip, measure the inside of the recess rather than the outer edge of the frame, then subtract 1/8 inch from the diameter.

For a top sitting on a pedestal base, stability depends on the base, glass dimensions, weight and overhang. Check the base manufacturer’s guidance and ask our glass specialists to review your intended use before ordering. Our glass weight calculator estimates the finished piece’s weight.

Thickness. From 1/8 inch up to 3/4 inch, with the options available depending on the size of the piece. Which you need depends mostly on how the glass will be supported.

If the top will sit on an existing surface — protecting a wooden table, a desk or a dresser — 1/4 inch is the usual choice, and the most common thickness we cut.

If the top will sit on legs or a frame, with areas of glass unsupported underneath, thicker glass is generally more appropriate: 3/8 inch or 1/2 inch.

The load a glass top can support depends on its dimensions, thickness, support arrangement and intended use. Thickness alone does not establish a safe load rating.

Thickness is also an aesthetic choice — a thicker edge reads as more substantial — but it adds significantly to both weight and price. Check the weight of your exact configuration in our glass weight calculator before you order.

If you have a specific weight-bearing requirement, check with our glass specialists before purchasing.

Glass type. Clear glass has high clarity with a minimal greenish tint. Gray and bronze are tinted. Opaque obscures what is beneath it. HDglass is our low-iron glass — clearer, with less of the greenish tint.

Edge work. Flat polish gives a smooth, shiny edge with a minimal look. Pencil polish has a rounded profile. Beveled cuts an angled facet around the perimeter for a decorative finish. Seamed is a basic ground finish rather than a decorative polish. Check the options and price available for your configuration, and ask our glass specialists which finish suits your installation.

A tempering stamp identifies glass as tempered. Whether a permanent mark is required depends on the application and applicable requirements. If you are unsure which option to select, check with our glass specialists before purchasing.

Where available for your configuration and appropriate for your application, you can choose glass with or without the tempering stamp.

Patio and bistro tables, pedestal side tables, hall and console tables, plant stands, and as a protective layer over a wooden top you want to keep free of heat rings, scratches and spills.

Each piece is made to the measurements and options you select, within the stated cutting tolerance. When tempered glass is selected, cutting, edge work and any approved holes are completed before heat treatment. Tempered glass cannot be cut or drilled afterwards, so confirm all dimensions and features before ordering.

Tempering changes the glass’s strength and breakage behaviour, but glass can still break and cause injury. Choose a configuration and support arrangement appropriate for the intended use.

• Custom square glass table tops
• Custom rectangle glass table tops
• Round glass table tops
• Glass table tops
• Glass weight calculator
• Quarter-round table top customizer